ASTM A666 PDF
L Stainless Steel Sheet. ASTM A Characteristics. / L stainless steel sheet exhibits high strength, toughness and high temperature resistance. The following alloys meet the ASTM-A standard. Select an alloy for product specifications: stainless steel provides high strength and good ductility. ASTM A Standard Specification for Annealed or Cold-Worked _机械 /仪表_工程科技_专业资料。ASTM A Standard.
|Published (Last):||4 October 2016|
|PDF File Size:||8.49 Mb|
|ePub File Size:||12.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM A666 for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
The values obtained in this manner should not, however, be taken as the actual yield strength for 0. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. The steels shall adhere to specified chemical composition requirements.
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Only annealed conditions of grades speci? It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
An alternative method of determining?
The values given in parentheses are for information only. This standard has been approved for use by agencies of the Department of Defense.
This abstract is a brief summary of the referenced standard. The ast, shall be subjected to tension test, free-bend test, and controlled-bend or V-block test. Depending on the work hardening characteristics of the particular grade, either the yield or the tensile strength can be the controlling factor in meeting the properties. Rockwell B 95 95 The noncontrolling factor normally will exceed considerably the speci?
ASTM A for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
C Annealed material that naturally meets mechanical properties may be applied. Link to Active This link will always route to the current Active version zstm the standard. Originally approved in Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. The values given in parentheses are for information only.
Mechanical properties such as yield strength, tensile strength, elongation, hardness, and bending shall be determined. Only annealed conditions of grades specifically approved by the ASME code are permitted for pressure vessel use. One bend test shall be made from one end of each coil.
A superscript epsilon e indicates an editorial change since the last aastm or reapproval.
This standard is aastm to revision at any time by the responsible technical committee and must be reviewed every? ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Current edition approved Oct. This specification covers austenitic stainless steels in the annealed and normally required cold-worked conditions.
A — 03 Standard Speci? Hard Elongation in 2 in. D PSS means plate, strip, sheet.
ASTM A Standard Specification for Annealed or Cold-Worked_百度文库
HardC Elongation in 2 in. ICS Number Code However, in the case of dispute, tests shall be made by pressure. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Asttm Headquarters.